Play with dies/ DT StampArtic

Hello everyone.

Today I am doing a blogpost for StampARTic

 I want to show you an easy way to make 3D project with dies.

Tim Holtz dies is very easy to use in 3D project.
 You can cut out from cardboard, soda can and so one..

I use cardboard to for the construction.

You will need two cars in cardboard.

Cut a strip 7x12 cm, and score on 1 and 6 cm, and then you have to cut small notches on both sides.

You are now ready to glue the strip to the car. Remember to use liquide glue.

One side is glued together.

Both of the car dies is glued on the strip.

Front.

Side.

Rear.

I hope you did understand explanation. It takes a little bit of patience and accuarcy.

Now it is time to have some fun, and decorate the car.

On this project I have used Graphic 45 papers from 

"Come away with me" and "Raining Cats and Dogs"

All the fussy cut is from "Raining Cats and Dogs"

I have used a large quantity of flowers from Wild Orcide Craft.

Back at the car. The kitten is sitting in a door pull from G45.

Here you can see the car from the side.

In the backside on the car I have used a stamp from IndigoBlu.

On the front you can take away the panel, so you can write a greeting. 

I have used magnets to hold the panel with fussy cut on to the car.

I hope you did like this project.

Gunn-Eirill